How To Proceed With Troubleshooting

HINT:

• Use this procedure to troubleshoot the power steering system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 
3. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

4. INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B: Go to step  8

   A: Go to Next step 

5. CHECK FOR DTC* 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B: Go to step  8

   A: Go to Next step 

6. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  8

   A: Go to Next step 

7. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. (see TERMINALS OF ECU  ).
   2. (see DATA LIST / ACTIVE TEST  ).
8. REPAIR OR REPLACE 
9. CONFIRMATION TEST 

   NEXT: END