Diagnostic Trouble Code Chart

HINT: 

• If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor connections.
• If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to DTC CHART OF ABS:  for the respective "DTC Code" in the DTC chart.
• When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
• For DTCs indicated by the warning light or indicator light, refer to DTC CHECK / CLEAR  the DTC charts in DTC Check/Clear.
• Inspect the fuses and relays before inspecting the trouble areas shown in the table below.

*1, *2:

Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

• *1:
  1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
  2. Clear the DTC.

• *2:
  1. Keep the vehicle in the stationary condition for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
  2. Drive the vehicle at the vehicle speed of 50 km/h (31 mph) and keep depressing the brake pedal strongly for approximately 3 seconds.
  3. Repeat the above operation 3 times or more and check that the ABS warning light goes off.
  4. Clear the DTC.

HINT: 

In some cases, Techstream cannot be used when the ABS warning light remains on.

HINT: 

In some cases, the Techstream cannot be used when the SLIP indicator light remains on.