Data List / Active Test

HINT:

By accessing the DATA LIST displayed on the intelligent tester, values of switches and sensors can be checked without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method to save diagnostic time.

1. DATA LIST FOR OCCUPANT CLASSIFICATION ECU 
   1. Connect the intelligent tester to the DLC3.
   2. Turn the engine switch on (IG).
   3. Turn the tester on.
   4. Enter the following menus: DIAGNOSIS / OBD/ MOBD / OCCUPANT DETECT / DATA LIST.
   5. Check the values by referring to the table below.

      HINT:

      The Specified Condition for Zero Point Calibration in the table below must be satisfied when the zero point calibration is performed.

      Fig 1: Connecting Intelligent Tester To DLC3

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      DATA LIST: 

      DATA LIST
      
      

      Tester Display	Measurement Item/ Range	Normal Condition	Specified Condition for Zero Point Calibration	Diagnostic Note
      PASSENGER CLASS	Passenger classification/ NG: Data is not determined AM50: Adult is seated and seat is in rear position AF05: Adult is seated and seat is in front position CHILD: Child is seated OFF: Vacant	AM50/AF05/CHILD/OFF	OFF	-
      P BUCKLE SW	Buckle switch (Passenger side)/ SET: Passenger side seat belt is fastened UNSET: Passenger side seat belt is unfastened NG: Data is not determined	UNSET/SET	UNSET	-
      RELATIVE PRESS	Pressure sensor output/ Min.: 0 Max.: 255	0 to 210	0 to 2	-
      FILTERED PRESS	Filtered pressure sensor output/ Min.: 0 Max.: 255	38 to 240	38 to 75	If value is outside range of Specified Condition for Zero Point Calibration, check whether any objects placed on seat cushion and that seat cushion fitted correctly.
      THERMISTOR TEMP	Thermistor temperature output/ Min.: -40°C (40°F) Max.: 90°C (194°F)	-40° to 85°C (-40° to 185°F)	3° to 40°C (36° to 104°F)	If value is outside range of Specified Condition for Zero Point Calibration, adjust temperature to proper range by using air conditioner, etc.
      WEIGHT THRESH	Weight threshold/ Min.: 0 Max.: 255	36 to 67 (reference value)	36 to 67 (reference value)	-
      FILTERED TENSION	Filtered belt tension output/ Min.: 0 Max.: 255	39 to 229	39 to 64 (no load)	-
      EMPTY THRESH	Empty threshold value from seat factory/ Min.: 0 Max.: 255	38 to 75	38 to 75	-
      ALLOW THRESH	Threshold value for adult passenger or not from seat factory/ Min.: 0 Max.: 255	43 to 64 (reference value)	43 to 64 (reference value)	-
      #PRESENT CODES	Number of present trouble codes/ Min.: 0 Max.: 255	0	0	-
      #PAST CODES	Number of past trouble codes/ Min.: 0 Max.: 255	0	0	-