LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (4GR-FSE) - DTC P0604 - P2A03, DTC U0101 >> DTC P2A00 A/F Sensor Circuit Slow Response (Bank 1 Sensor 1); DTC P2A03 A/F Sensor Circuit Slow Response (Bank 2 Sensor 1) >> Confirmation Driving Pattern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Driving Pattern

HINT:

Performing this confirmation pattern will activate the A/F sensor response monitor.

Fig 1: Vehicle Speed - Driving Pattern
G05316553Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect Techstream to the DLC3.
  2. Turn the engine switch on (IG).
  3. Turn the tester on.
  4. Clear DTCs (where set).
  5. Select the following menu items: Powertrain / Engine and ECT / Monitor / O2 Sensor / Details.
  6. Check that RES RATE B1S1 is Incomplete.
  7. Start the engine and warm it up (Procedure "A").
  8. Drive the vehicle at between 25 mph and 75 mph (40 km/h and 120 km/h) for 3 minutes. However, the vehicle should be driven at a constant speed (Procedure "B").
  9. Check the monitor result values on Techstream by selecting the following menu items: Powertrain / Engine and ECT / Monitor / O2 Sensor / Details /RES RATE B1 S1 and RES RATE B2 S1.
  10. If the values indicated on the tester do not change, perform READINESS MONITOR DRIVE PATTERN for the A/F sensor and the heated oxygen sensor (See FREEZE FRAME DATA ).

    HINT:

    Completion of all A/F sensor monitors is required to change the value in TEST RESULT.

  11. Note the value of the Monitor Result.
  12. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes / Pending.
  13. Check if any DTCs (any pending DTCs) are set.
scientia non olet · About LEMON Manuals