DTC 01-D5 Absence of Registration Unit; DTC 01-D8 No Response for Connection Check; DTC 01-D9 Last Mode Error; DTC 01-DA No Response Against ON / OFF Command; DTC 01-DB Mode Status Error; DTC 01-DE Slave Reset: Description
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTION CONDITION CHART
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-D5 *1, *3 |
|
|
| 01-D8 *2, *3 | A component shown by the sub-code is (was) disconnected from the system after engine start | |
| 01-D9 *1, *3 | The device that had functioned before the engine stopped is (was) disconnected from the system when the engine switch is (was) on (IG or ACC) | |
| 01-DA *3 |
|
|
| 01-DB *1, *3 | A dual alarm is detected | |
| 01-DE *3 | A slave device has been disconnected after engine start | |
HINT.
|
||
NOTE:
- Before starting troubleshooting, be sure to clear DTCs stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The multi-display is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.