How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the dynamic radar cruise control system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS 
3. PROBLEM SYMPTOM CONFIRMATION 

   Result 

   RESULT CHART
   
   

   Condition	Proceed to
   Symptom occurs	A
   Symptom does not occur	B

   A: Go to step 4 

   B: SYMPTOM SIMULATION 

4. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, replace or recharge the battery before proceeding. 

5. CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN) 
   1. Use the Techstream to check if the multiplex communication system (MPX) is functioning normally.

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B:  Go to MULTIPLEX COMMUNICATION SYSTEM

   A: Go to Next Step 

6. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN) 
   1. Use the Techstream to check for normal function of the CAN communication system.
   2. Check for DTCs.

      Result 

      RESULT CHART
      
      

      Condition	Proceed to
      DTC is not output	A
      DTC is output	B

   B:  Go to CAN COMMUNICATION SYSTEM

   A: Go to Next Step 

7. DTC CHECK 

   Result 

   RESULT CHART
   
   

   Condition	Proceed to
   DTC is output	A
   DTC is not output	B

   B:  Go to step  9

   A: Go to Next Step 

8. DTC CHART 

   NEXT:  Go to step  10

9. PROBLEM SYMPTOMS TABLE 
10. CIRCUIT INSPECTION 
11. TERMINALS OF ECM 
12. IDENTIFICATION OF PROBLEM 
13. REPAIR OR REPLACE 
14. CONFIRMATION TEST 

    NEXT: END