Camshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE CAMSHAFT POSITION SENSOR
1. Disconnect the camshaft position sensor connector.
2. Remove the bolt and camshaft position sensor.
  
  Fig 1: Locating Camshaft Position Sensor And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VVT SENSOR (for Bank 1)
1. Separate the 3 wire harness clamps
  
  Fig 2: Locating Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the VVT sensor connectors.
3. Remove the 2 bolts and 2 VVT sensors.
  
  Fig 3: Locating VVT Sensor Connectors And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VVT SENSOR (for Bank 2)
1. Separate the wire harness clamp.
  
  Fig 4: Locating Wire Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the VVT sensor connectors.
3. Remove the 2 bolts and 2 VVT sensors.
  
  Fig 5: Locating VVT Sensor Connectors And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002