LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Automatic Transaxle) >> Transmission Control Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION CONTROL SWITCH 
    1. Apply MP grease to the hatched area of the shift lever guide housing as indicated in the illustration.
      Fig 1: Identifying MP Grease Applying Area
      G05318256Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the transmission control switch to the shift lever guide housing.
      NOTE: Securely engage the claws.
      Fig 2: Locating Transmission Control Switch From Shift Lever Guide Housing
      G05318249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the shift lever guide housing with the shift lever lock pin and a new shift lever support
      NOTE:
      • Install the shift lever nut and lock pin after first engaging the 2 claws.
      • Securely engage the claws.
        Fig 3: Locating Shift Lever Guide Housing
        G05318248Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the transmission control switch connector to the floor shift assembly.
    Fig 4: Locating Transmission Control Switch Connector
    G05318247Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY  (See REASSEMBLY  )
  3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  (See INSTALLATION  )
  4. ADJUST SHIFT LEVER POSITION  (See ADJUSTMENT  )
  5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR  (See INSTALLATION )
  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  7. CONNECT HEATED OXYGEN SENSOR  (See INSTALLATION )
  8. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  9. INSTALL REAR NO. 1 FLOOR PANEL BRACE  (See INSTALLATION )
  10. INSTALL NO. 2 FLOOR UNDER COVER  (See INSTALLATION )
  11. INSTALL NO. 1 FLOOR UNDER COVER  (See INSTALLATION )
  12. INSTALL NO. 2 CONSOLE BOX DUCT  (See INSTALLATION )
  13. INSTALL CONSOLE BOX  (See INSTALLATION )
  14. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  15. INSTALL REAR ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  16. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  17. INSTALL CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  18. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH  (See INSTALLATION )
  19. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH  (See INSTALLATION )
  20. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  22. INSPECT SHIFT LEVER POSITION  (See ON-VEHICLE INSPECTION  )
  23. INSPECT FOR EXHAUST GAS LEAK 
scientia non olet · About LEMON Manuals