Combination Meter: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COMBINATION METER ASSEMBLY
1. Position the combination meter assembly on the steering column as shown in the illustration.
  NOTE: Do not damage the instrument panel safety pad or combination meter assembly.
2. Connect the connectors.
  
  Fig 1: Positioning Combination Meter Assembly On Steering Column
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 2 positioning pins of the combination meter assembly.
4. Engage the 2 claws and install the combination meter assembly
5. Remove the protective tape
INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Install the 2 clips
  
  Fig 3: Identifying Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the instrument cluster finish panel sub-assembly with the 2 screws.
Fig 4: Locating Screws And Instrument Cluster Finish Panel Sub-Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL LH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )
INSTALL STEERING COLUMN COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).