Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG)
3. Turn the Techstream on
4. Enter the following menus. Body Electrical / Combination Meter / Active Test
5. Check the CRUISE main indicator light by performing the Active Test

   Combination Meter 

   ACTIVE TEST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat Lamp Cruise	CRUISE main indicator light	OFF or ON	Confirm that the vehicle is stopped, engine idling

   OK: CRUISE main indicator light blinks/goes off. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See COMBINATION METER )

OK: Go to next step 

1. Connect the Techstream to the DLC3
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Cruise Control / Data List.
5. Check the Data List for proper functioning of the CRUISE main indicator light

   Cruise Control (ECM) 

   DATA LIST
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU)/ON or OFF	ON "CRUISE" on OFF "CRUISE" off	-

   OK: When the cruise control main switch is operated, the display changes as shown above. 

NG: REPLACE ECM (for 2UR-GSE)  (See ECM )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )