Inspection Procedure
NOTE:
When the distance control ECU or ECM is replaced with a new one, initialization must be performed (See INSTALLATION
).
- REPLACE ECM
- Replace the ECM (for 2UR-GSE) (See ECM )
- CHECK DTC
- Clear the DTC (See DTC CHECK / CLEAR )
- Turn the cruise control main switch on.
- Drive the vehicle at the require speed (45 km/h (27 mph) or higher).
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
)
Result
RESULT REFERENCEResult Proceed to DTC P1616 is not output A DTC P1616 is output B
B: REPLACE DISTANCE CONTROL ECU (See DISTANCE CONTROL ECU )
A: END