Customize Parameters

CUSTOMIZING FUNCTION WITH TECHSTREAM

HINT

The items in the table below can be customized.

NOTE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current setting before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

HINT

The following functions default settings are ON Parts of these functions can be customized

Connect the Techstream to the DLC3
Turn the engine switch on (IG)
Turn the Techstream on
Enter the following menu Customize Setting

Select the setting by referring to the table below

Smart Key / Access

SMART KEY AND ACCESS REFERENCE CHART

Tester Display	Default	Content	Setting
Ignition Available Area	ALL	Function that switches the entry ignition detection area	FRONT/ALL
Park Wait Time	2 5s	Function that sets waiting time to permit opening door after door is locked with entry lock function	0 5 s/1 5 s/2 5 s/5 s
Trunk Open Mode	ON	Function to permit opening luggage compartment door	ON/OFF
Key Low Battery Warning	ON	Function that warns driver that key's battery is low	ON/OFF

Entry Unlock Mode Switching Function
1. To change the vehicle to entry unlock mode switching function, make sure that the vehicle power is off and simultaneously press and hold the electrical key's LOCK switch and another electrical key switch for 5 seconds
  Driver door unlock default setting
  
  When the switches are pressed and held for 5 seconds, the entry door unlock mode changes in the following order driver door mode, all door mode.
  
  NOTE: After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.
  - Driver door unlock mode
    When the driver door's touch sensor is touched, only the driver door unlocks When another touch sensor is touched, all doors unlock
  - All door unlock mode
    When the touch sensor is touched, all doors unlock
2. The certification ECU (smart key ECU assembly) receives this signal from the entry door control receiver and changes the smart access system with push-button start to the entry unlock mode
3. The certification ECU (smart key ECU assembly) sounds the buzzers of the wireless door lock buzzer and combination meter to inform the user that the mode has been switched
  
  Fig 1: Combination Meter Information Diagram
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT
  
  The function only changes the entry unlock mode of the smart access system with push-button start It does not switch the unlocking of the wireless door lock control
Electrical Key Cancel
The electrical key cancel operation disables the following functions
- Entry Unlock/Lock
- Entry Luggage Compartment Open
- Electrical Key Lock-in Prevention
- Warning
- Memory Call
1. The operation procedures are as follows Precondition
  Engine switch off, driver side door closed and unlocked.
  1. Unlock the driver side door once with the UNLOCK switch of the electrical key
  2. Open the driver door within 5 seconds
  3. Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds
  4. Close and open the driver door twice within 30 seconds.
    (Driver door Close → Open → Close → Open)
  5. Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds
  6. Close and open the driver door within 30 seconds
    (Driver door Close → Open)
  7. Close the driver door within 5 seconds. When electrical key cancel is activated, the wireless door lock buzzer sounds twice To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once