September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Yaw Rate And Acceleration Sensor: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See
INITIALIZATION
).
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
(See
REMOVAL
)
- REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
(See
REMOVAL
)
- REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
(See
REMOVAL
)
- REMOVE CONSOLE PANEL SUB-ASSEMBLY
(See
REMOVAL
)
- REMOVE FRONT ASH RECEPTACLE ASSEMBLY
(See
REMOVAL
)
- REMOVE REAR ASH RECEPTACLE ASSEMBLY
(See
REMOVAL
)
- REMOVE CONSOLE BOX REGISTER ASSEMBLY
(See
REMOVAL
)
- REMOVE CONSOLE BOX
(See
REMOVAL
)
- REMOVE NO. 2 CONSOLE BOX DUCT
(See
REMOVAL
)
- REMOVE YAW RATE AND ACCELERATION SENSOR
- Separate the 2 wire harness clamps.
- Remove the 2 bolts and yaw rate and acceleration sensor.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Disconnect the yaw rate and acceleration sensor connector.
NOTE:
Do not remove the sensor from the bracket.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002