Customize Parameters

1. CUSTOMIZE PARAMETERS 
   NOTE:

   • When the customer requests a change in a function, first make sure that the function can be customized.
   • Be sure to make a note of the current settings before customizing.
   • When troubleshooting a function, first make sure that the function is set to the default setting.
   1. Connect the Intelligent tester or Techstream to the DLC3.
   2. Turn the power switch ON (IG).
   3. Turn the tester on.
   4. Enter the following menus:
      1. Intelligent tester - Select. CUSTOMIZE /
      2. Techstream - Select Customize Setting /
   5. Select the setting by referring to the table below
      1. Intelligent tester

         WARNING 

         CONTENTS SETTING CHART
         
         

         Display	Default	Contents	Setting
         FR SENSOR RANGE	WIDE	Function to set buzzer activation range (for front sensors)	NARROW or WIDE
         RR SENSOR RANGE	WIDE	Function to set buzzer activation range (for rear sensors)	NARROW or WIDE
         KEEP SENSE BUZ	AVAIL	Function to make buzzer sound when distance between vehicle and obstacle does not change for more than 3 seconds	NOT AVAIL or AVAIL
         F&R BUZZER FREQ	MIDDLE	Buzzer sounding frequency	LOW, MIDDLE or HIGH
         F&R BUZZER VOLM	M2	Buzzer volume setting	L, M1, M2, M3 or H

         SENSOR 

         CONTENTS SETTING CHART
         
         

         Display	Default	Contents	Setting
         SENSOR COND/N	AVAIL	Function to make sensors available when shift position is N	NOT AVAIL or AVAIL
         F SIDE DIST SEN	LONG	Function to set buzzer activation range (for front sensors)	SHORT or LONG
         REV RNG FR SENS	FSDE	Operation setting for vehicle front sensors (front center, front corner, front side) when shift lever is in R position	F, Fs, Fc, FSDE or F STOP
         NON-P/R RR SENS	RSTOP	Operation setting for vehicle rear sensors (rear center, rear corner) when shift lever is in position other than P or R	R, RCRN or R STOP

         DISPLAY 

         CONTENTS SETTING CHART
         
         

         Display	Default	Contents	Setting
         APPRCH DISP OFF	AVAIL	Display when moving away from previously detected obstacle	NOT AVL or AVAIL
         DISPLAY MODE	ALL	Display mode setting (when intuitive parking assist system is normal)	ALL or UNDISP

      2. Techstream

         Warning 

         CONTENTS SETTING CHART
         
         

         Display	Default	Contents	Setting
         Fr Sensor Onset Range	Wide	Function to set buzzer activation range (for front sensors)	Narrow or Wide
         Rr Sensor Onset Range	Wide	Function to set buzzer activation range (for rear sensors)	Narrow or Wide
         Keep Sense Buzzer	Avail	Function to make buzzer sound when distance between vehicle and obstacle does not change for more than 3 seconds	Not Avail or Avail
         Fr & Rr Buzzer Freq	Middle	Buzzer sounding frequency	Low, Middle or High
         Fr & Rr Buzzer Volume	M2	Buzzer volume setting	L, M1, M2, M3 or H

Sensor 

Display