Terminals Of Ecu

CHECK TELEVISION CAMERA ASSEMBLY

Fig 1: Identifying Television Camera Assembly Connector S35

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage and resistance according to the value (s) in the table below

CONNECTOR TERMINAL REFERENCE CHART

Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
S35-3 (CGND) - Body ground	R - Body ground	Ground	Always	Below 1 Ω
S35-4 (CB+) - S35-3 (CGND)	B - R	Power source	Power switch ON (IG), shift lever R position	5 8 to 6 5 V

If the result is not as specified, there may be a malfunction on the wire harness side.

Measure the waveform according to the value (s) in the table below.

CONNECTOR TERMINAL REFERENCE CHART

Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
S35-2 (CV+) - S35-1 (CV-)	W - Shielded	Display signal	Power switch ON (IG), shift lever R position	See waveform e 1

If the result is not as specified, the camera may have a malfunction.

Waveform 1 (Reference)

WAVEFORM REFERENCE CHART

Item	Content
Terminal No (Symbols)	S35-2 (CV+) - S35-1 (CV-)
Tool Setting	0 2 V/DIV, 0 2 μs/DIV
Condition	Power switch ON (IG), Shift lever R position

CHECK MULTI-DISPLAY (See TERMINALS OF ECU )
CHECK DISPLAY AND NAVIGATION ASSEMBLY (See TERMINALS OF ECU )

Fig 2: Identifying Waveform (Reference)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002