LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> LS 600hL >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Cellular Communication >> LEXUS Link System >> DTC 2-3: Digital Signal Processor Communication Error; DTC 2-4: GPS Communication Error >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. RESET MAYDAY ECU 
    1. Exit diagnosis mode and wait for 10 seconds
    2. Disconnect the cable from the negative (-) battery terminal, and wait for 10 minutes
      NOTE:
      • After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
    3. Reconnect the cable to the negative (-) battery terminal, and wait for 10 seconds
      NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
    4. Turn the power switch ON (IG), and then check for the current DTC and historic DTC again (see DTC CHECK / CLEAR )

    Result 

    RESULT CHART

    Result Proceed to
    Current DTC 2-3 or 2-4 exists A
    Historic DTC 2-3 or 2-4 exists B

    B: CLEAR HISTORIC DTC  (See DTC CHECK / CLEAR )

    A: REPLACE MAYDAY ECU TOGETHER WITH MAYDAY BATTERY AND THEN PERFORM REGISTRATION 

scientia non olet · About LEMON Manuals