How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the intuitive parking assist system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11V, replace or recharge the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B: Go to CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

   A: Go to Next Step 

4. CHECK FOR DTC 
   1. Check for DTCs (See DTC CHECK / CLEAR  ).
   2. Clear the DTCs (See DTC CHECK / CLEAR  ).
   3. Recheck for DTCs (See DTC CHECK / CLEAR  ).

      Result 

      DTC RESULT REFERENCE
      
      

      Result	Proceed to
      No DTC is output	A
      DTC is output	B

   B: Go to DIAGNOSTIC TROUBLE CODE CHART  (See )

   A: Go to Next Step 

5. PROBLEM SYMPTOMS TABLE 
   1. Refer to the PROBLEM SYMPTOMS TABLE  (See ).

      Result 

      DTC RESULT REFERENCE
      
      

      Result	Proceed to
      Fault is not listed in problem symptoms table	A
      Fault is listed in problem symptoms table	B

   B:  Go to step  7

   A: Go to Next Step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Operation Check (See OPERATION CHECK  ).
   2. Terminals of ECU (See TERMINALS OF ECU  ).
   3. Data List / Active Test (See DATA LIST / ACTIVE TEST  ).
7. ADJUST, REPAIR OR REPLACE 
8. CONFIRMATION TEST 

   NEXT: END