Air Injection Driver: Installation

INSTALL AIR INJECTION CONTROL DRIVER ASSEMBLY
1. Install the air injection control driver with the 3 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 1: Locating Air Injection Control Driver Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 4 air injection control driver connectors.
  
  Fig 2: Locating Air Injection Control Driver Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the wire harness clamp.
4. Connect the ground wire with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )

Fig 3: Locating Ground Wire Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002