Section 11 (Cooling): Radiator: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FAN SHROUD SUB-ASSEMBLY (See INSTALLATION )
INSTALL RADIATOR ASSEMBLY
1. Install the 2 grommets to the radiator.
2. Install the 2 radiator support brackets with the 2 nuts.
  Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf)
3. Connect the cooling fan ECU connector.
  
  Fig 1: Identifying Radiator Support Brackets With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the outlet duct.
  
  Fig 2: Identifying Outlet Duct
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT NO. 1 OIL COOLER OUTLET TUBE
1. Connect the outlet tube.
  
  Fig 3: Locating Outlet Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT NO. 1 OIL COOLER INLET TUBE
1. Connect the inlet tube.
  
  Fig 4: Locating Inlet Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT NO. 2 RADIATOR HOSE
1. Connect the radiator hose.
  
  Fig 5: Locating Radiator Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT NO. 1 RADIATOR HOSE
1. Connect the radiator hose.
INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
INSTALL INTAKE AIR CONNECTOR PIPE (See INSTALLATION )
INSTALL V-BANK COVER (See INSTALLATION )
INSTALL RADIATOR RESERVE TANK ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
ADD ENGINE COOLANT (See COOLANT )
CHECK FOR ENGINE COOLANT LEAKS (See COOLING SYSTEM )
INSTALL ENGINE UNDER COVER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 6: Locating Radiator Hose

PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.