LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> SC 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Lighting) >> License Plate Light Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

License Plate Light Assembly: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL LICENSE PLATE LIGHT ASSEMBLY 
    1. Attach the claw to install the license plate light.
      Fig 1: Locating License Plate Light Claws
      G05292766Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR BUMPER COVER (See  INSTALLATION  ) 
  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE RH (See  REASSEMBLY  ) 
  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE LH (See  REASSEMBLY  ) 
  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT (See  REASSEMBLY  ) 
  6. INSTALL REAR FLOOR FINISH SIDE PLATE LH (See  REASSEMBLY  ) 
  7. INSTALL REAR FLOOR FINISH SIDE PLATE RH (See  REASSEMBLY  ) 
  8. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LOWER (See  REASSEMBLY  ) 
  9. INSTALL TONNEAU COVER ASSEMBLY (See  REASSEMBLY  ) 
  10. INSTALL TONNEAU COVER STOPPER SUB-ASSEMBLY RH (See  REASSEMBLY  ) 
  11. INSTALL TONNEAU COVER STOPPER SUB-ASSEMBLY LH (See  REASSEMBLY  ) 
  12. INSTALL LUGGAGE COMPARTMENT TRIM REAR COVER SUB-ASSEMBLY (See  REASSEMBLY  ) 
  13. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (See  REASSEMBLY  ) 
  14. INSTALL TOOL BOX COVER (See  REASSEMBLY  ) 
  15. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH (See  REASSEMBLY  ) 
  16. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH (See  REASSEMBLY  ) 
  17. INSTALL LUGGAGE COMPARTMENT FLOOR MAT 
  18. INSTALL SPARE TIRE 
  19. INSTALL SPARE WHEEL COVER ASSEMBLY 
  20. INSTALL REAR FLOOR FINISH PLATE (See  REASSEMBLY  ) 
  21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  22. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals