Rear Combination Light Assembly: Installation

HINT:

• Use the same procedures for the RH and LH side.
• The procedures listed below are for the LH side.

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH 
   1. Attach the rear combination light with the 2 pins and install the light guide of the body side.
      Fig 1: Identifying Rear Combination Light Pins

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the connector.
      Fig 2: Locating Rear Combination Light Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL REAR LIGHT COVER LH 
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE LH (See  REASSEMBLY  ) 
4. INSTALL REAR FLOOR FINISH SIDE PLATE LH (See  REASSEMBLY  ) 
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT (See  REASSEMBLY  ) 
6. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LOWER (See  REASSEMBLY  ) 
7. INSTALL TONNEAU COVER ASSEMBLY (See  REASSEMBLY  ) 
8. INSTALL LUGGAGE COMPARTMENT TRIM REAR COVER SUB-ASSEMBLY (See  REASSEMBLY  ) 
9. INSTALL TOOL BOX COVER (See  REASSEMBLY  ) 
10. INSTALL SPARE TIRE 
11. INSTALL SPARE WHEEL COVER ASSEMBLY 
12. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH (See  REASSEMBLY  ) 
13. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH (See  REASSEMBLY  ) 
14. INSTALL LUGGAGE COMPARTMENT FLOOR MAT 
15. INSTALL REAR FLOOR FINISH PLATE (See  REASSEMBLY  ) 
16. INSTALL TONNEAU COVER STOPPER SUB-ASSEMBLY LH (See  REASSEMBLY  ) 
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
18. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.