Engine Coolant Temperature Sensor: Installation: Installation
WARNING: This page is about a different car, the 2009 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE COOLANT TEMPERATURE SENSOR
- Install a new gasket to the engine coolant temperature sensor.
- Install the engine coolant temperature sensor.
Torque: 20 N*m ( 204 kgf*cm, 15 ft.*lbf)
- Connect the engine coolant temperature sensor connector.
- INSTALL INTAKE MANIFOLD . Refer to INSTALLATION - Step 12
- INSTALL INTAKE AIR SURGE TANK ASSEMBLY . Refer to INSTALLATION - Step 13
- INSTALL COLD START INJECTOR . Refer to INSTALLATION - Step 1
- INSTALL THROTTLE BODY See step 1
- INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE See step 2
- CONNECT NO. 2 VENTILATION HOSE See step 3
- ADD ENGINE COOLANT . Refer to ON-VEHICLE INSPECTION - Step 5
- INSPECT FOR COOLANT LEAK . Refer to ON-VEHICLE INSPECTION - Step 1
- INSPECT FOR FUEL LEAK . Refer to ON-VEHICLE INSPECTION - Step 1
- INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 3
- INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH . Refer to INSTALLATION - Step 4
- INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH . Refer to INSTALLATION - Step 5
- INSTALL FRONT WIPER ARM HEAD CAP . Refer to INSTALLATION - Step 6
- INSTALL ROOF DRIP SIDE FINISH MOULDING RH
- INSTALL ROOF DRIP SIDE FINISH MOULDING LH
- INSTALL FRONT FENDER PROTECTOR UPPER RH . Refer to INSTALLATION - Step 9
- INSTALL FRONT FENDER PROTECTOR UPPER LH . Refer to INSTALLATION - Step 29
- INSTALL V-BANK COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 115
- INSTALL ENGINE ROOM SIDE COVER LH . Refer to INSTALLATION - Step 116
- INSTALL ENGINE ROOM SIDE COVER RH . Refer to INSTALLATION - Step 117
- INSTALL COOL AIR INTAKE DUCT SEAL . Refer to INSTALLATION - Step 118