Front Speed Sensor: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Wipe off sealant attached to the front speed sensor's fitting surface with a non-residue solvent.
  NOTE:
  Prevent foreign matter from attaching to the sensor rotor.
2. Install a new front speed sensor to the hub and bearing assembly. The front speed sensor connector should be positioned upward.
  
  Fig 1: Identifying Front Speed Sensor Connector Should Be Positioned Upward
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, install the front speed sensor onto the front axle hub and bearing.
  
  Fig 2: Identifying Skid Control Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09214-76011
  NOTE:
  - Keep the front speed sensor away from magnets.
  - Do not use a hammer on the front speed sensor.
  - Check that there is no foreign matter such as iron chips on the front speed sensor's detecting portion.
  - Slowly press the front speed sensor straight.
INSTALL FRONT AXLE HUB SUB-ASSEMBLY WITH FRONT SPEED SENSOR . Refer to INSTALLATION - Step 1
INSPECT FRONT AXLE HUB BEARING FOR LOOSENESS . Refer to ON-VEHICLE INSPECTION - Step 4
INSPECT FRONT AXLE HUB FOR RUNOUT . Refer to ON-VEHICLE INSPECTION - Step 5
INSTALL FRONT DISC . Refer to INSTALLATION - Step 1
INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY . Refer to INSTALLATION - Step 6
CONNECT FRONT SPEED SENSOR WIRE
1. Connect the front speed sensor wire to the front speed sensor.
  NOTE:
  Do not twist the sensor wire.
  
  Fig 3: Connecting Speed Sensor Connector To Front Speed Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CHECK FOR SPEED SENSOR SIGNAL
HINT:

Refer to TEST MODE PROCEDURE