Inspection Procedure

NOTE:

When the power window regulator motor assembly (for rear LH side) is reinstalled or replaced, the power window control system must be initialized.
After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be re-initialized by repeating the following operations at least 5 times:
1. Close the power window by fully pulling up the power window regulator switch assembly (for rear LH side) and holding it at the auto up position.
2. Open the power window by fully pushing down the power window regulator switch assembly (for rear LH side).
When the ECU determines that the power window regulator motor assembly (for rear LH side) has a malfunction, DTC B2311 is set.