DTC P1023: Camshaft Position Signal Output "B" Circuit; DTC P2614: Camshaft Position Signal Output Circuit / Open: Procedure
- REPLACE CAMSHAFT TIMING CONTROL MOTOR (BANK 1 AND/OR BANK 2)
- Replace the camshaft timing control motor. Refer to REMOVAL .
NEXT: Go to next step
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Connect the Techstream to the DLC3.
- Clear the DTC. Refer to DTC CHECK / CLEAR .
- Start the engine and idle it for 10 seconds.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Result
Display (DTC Output) Proceed to No output A Other DTCs B
B → See step 3
A → END
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART