Rear Combination Light Assembly: Installation: Installation

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR COMBINATION LIGHT ASSEMBLY
1. Engage the guide as shown in the illustration.
  
  Fig 1: Installing Rear Combination Light Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the rear combination light assembly with the 3 nuts.
3. Engage the 2 clamps.
  Torque: 6.8 N*m (69 kgf*cm, 60 in.*lbf)
4. Connect the connector.
INSTALL REAR BUMPER ASSEMBLY
Refer to INSTALLATION
INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER
1. Install the luggage compartment inner trim cover with the 2 clips.
INSTALL REAR FLOOR FINISH PLATE
1. Engage the 7 clips and install the rear floor finish plate.
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
1. Engage the 2 pins to install the 2 No. 1 luggage compartment trim hooks.
  
  Fig 2: Locating No. 1 Luggage Compartment Trim Hook Push Pins
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY
1. Engage the clip and install the luggage compartment side tray assembly.
2. Install the bolt.
INSTALL SPARE WHEEL COVER ASSEMBLY
INSTALL SPARE WHEEL COVER CLAMP
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
INSTALL REAR LIGHT ASSEMBLY
1. Install the rear light assembly with the 4 nuts.
  Torque: 6.8 N*m (69 kgf*cm, 60 in.*lbf)
2. Connect the connector.
INSTALL LUGGAGE COMPARTMENT DOOR COVER . Refer to INSTALLATION - Step 5