Cruise Control Main Switch: Installation: Installation

WARNING: This page is about a different car, the 2010 Lexus LS 460L and 2010 Lexus LS 460. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRUISE CONTROL MAIN SWITCH ASSEMBLY
1. Install the switch.
  
  Fig 1: Installing Cruise Control Main Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws.
  
  Fig 2: Locating Cruise Control Main Switch Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector and clamp.
  
  Fig 3: Locating Connector & Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD . Refer to INSTALLATION - Step 1
INSTALL SWITCH AND VOLUME CASE . Refer to INSTALLATION - Step 2
INSTALL NO. 2 STEERING WHEEL COVER LOWER . Refer to INSTALLATION - Step 3
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSTALL COWL TOP VENTILATOR LOUVER RH . Refer to INSTALLATION - Step 11
CHECK SRS WARNING LIGHT
1. Check the SRS warning light. Refer to DIAGNOSIS SYSTEM .