Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
P2765:
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever the following DTCs are not stored | P2767: Input speed sensor verify pulse input |
| Battery voltage | 8 V or higher |
| Engine switch | On (IG) |
| Starter | Off |
P2767:
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever the following DTCs are not stored | P0705: Transmission range switch circuit P0746, P0748: Shift solenoid valve SL1 P0776, P0778: Shift solenoid valve SL2 P0796, P0798: Shift solenoid valve SL3 P2765: Input speed sensor range check P2808, P2810: Shift solenoid valve SL4 P2817, P2819: Shift solenoid valve SL5 |
| Battery voltage | 8 V or higher |
| Engine switch | On (IG) |
| Starter | Off |
| Input speed sensor monitor status | Enable |
| Output shaft RPM | 1000 RPM or more (3rd, 4th, 5th or 6th) 1400 RPM or more (7th) |
| Park/neutral position switch | Off |
| Shift lever position | Not R |
| Engine | Running |