How To Proceed With Troubleshooting

HINT:

• The TCM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS 
3. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

4. CONNECT TECHSTREAM TO DLC3* 
5. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* 
   1. Refer to DTC CHECK/CLEAR  .
6. VISUAL INSPECTION 
7. SETTING CHECK MODE DIAGNOSIS* 
   1. Refer to CHECK MODE PROCEDURE  .
8. PROBLEM SYMPTOM CONFIRMATION 
   1. Refer to ROAD TEST  .

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      Symptom does not occur	A
      Symptom occurs	B

      B:  GO TO STEP  10

      A: Go to next step 

9. SYMPTOM SIMULATION 
   1. Refer to Electronic Circuit Inspection Procedure (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
10. DTC CHECK* 
    1. Refer to DTC CHECK/CLEAR  .

       Result 

       RESULT CHART
       
       

       Result	Proceed to
       DTC is not output	A
       DTC is output	B

       B:  GO TO STEP  18

       A: Go to next step 

11. BASIC INSPECTION 
    1. Refer to AUTOMATIC TRANSMISSION FLUID  .
    2. Refer to PARK/NEUTRAL POSITION SWITCH  .
    3. Refer to FLOOR SHIFT ASSEMBLY  .

       NG:  GO TO STEP  21

       OK: Go to next step 

12. MECHANICAL SYSTEM TESTS 
    1. Refer to MECHANICAL SYSTEM TESTS  .

       NG:  GO TO STEP  17

       OK: Go to next step 

13. HYDRAULIC TEST 
    1. Refer to HYDRAULIC TEST  .

       NG:  GO TO STEP  17

       OK: Go to next step 

14. MANUAL SHIFTING TEST 
    1. Refer to MANUAL SHIFTING TEST  .

       NG:  GO TO STEP  16

       OK: Go to next step 

15. PROBLEM SYMPTOMS TABLE CHAPTER 1 
    1. Refer to PROBLEM SYMPTOMS TABLE  .

       NG:  GO TO STEP  19

       OK: Go to next step 

16. PROBLEM SYMPTOMS TABLE CHAPTER 2 
    1. Refer to PROBLEM SYMPTOMS TABLE  .
17. PART INSPECTION 

    NG:  GO TO STEP  21

    OK: Go to next step 

18. DTC CHART 
    1. Refer to DIAGNOSTIC TROUBLE CODE CHART  .
19. CIRCUIT INSPECTION 
20. IDENTIFICATION OF PROBLEM 
21. REPAIR OR REPLACE 
22. CONFIRMATION TEST 

    NEXT: END