Cruise Control Main Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRUISE CONTROL MAIN SWITCH ASSEMBLY
1. Install the switch.
  
  Fig 1: Locating Cruise Control Main Switch Assembly Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws.
  
  Fig 2: Locating Cruise Control Main Switch Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector and clamp.
INSTALL STEERING PAD (See INSTALLATION ).
INSTALL SWITCH AND VOLUME CASE (See INSTALLATION ).

Fig 3: Locating Cruise Control Main Switch Assembly Connector And Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION ).
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).