LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Cruise Control) >> Object Recognition Ecu >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Object Recognition Ecu: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OBJECT RECOGNITION ECU 
    1. Attach the 2 clips
    2. Install the ECU with the 2 bolts

      Torque: 7.4 N*m (76 kgf*cm, 66 in.*lbf) 

    3. Connect the 2 connectors.
      NOTE: Do not use an ECU which has been dropped or subjected to any strong shocks.
      Fig 1: Locating Object Recognition ECU Connector Bolt And Clip
      G05776075Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION ).
  3. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION ).
  4. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)  (See INSTALLATION ).
  5. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY  (See INSTALLATION ).
  6. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION ).
  7. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION ).
  8. INSTALL ROPE HOOK  (See INSTALLATION ).
  9. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION ).
  10. INSTALL BATTERY SERVICE HOLE COVER  (See INSTALLATION ).
  11. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION ).
  12. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION ).
  13. ADJUST OBJECT RECOGNITION CAMERA  (See ADJUSTMENT ).
scientia non olet · About LEMON Manuals