Front Axle Hub Bolt: Replacement

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

REMOVE FRONT WHEEL
DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH (See REMOVAL )
REMOVE FRONT DISC (See REMOVAL )
REMOVE FRONT AXLE HUB BOLT LH
1. Using SST, remove the front axle hub bolt
  SST 09650-17011
  
  NOTE: Do not damage the threads of the hub bolts.
  
  Fig 1: Removing Front Axle Hub Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB BOLT LH
NOTE:
- Do not damage the threads of the hub bolts.
- Install nuts to prevent damage to the hub bolts.
1. Install a washer and nut to a new hub bolt as shown in the illustration.
  
  Fig 2: Installing Washer And Nut To Hub Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver or an equivalent to hold the hub, turn the nut to pull the hub bolt until the bottom surface of the hub bolt head touches the axle hub.
INSTALL FRONT DISC (See INSTALLATION )
CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)