LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Pre-Collision) >> Diagnostic Trouble Code Chart >> DTC C1A0A Front Radar Sensor Region Code Mismatch >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When the front millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (see REMOVAL ).
  1. CHECK FRONT MILLIMETER WAVE RADAR SENSOR 
    1. Using the Intelligent tester or Techstream, enter the following menus:
      1. Intelligent tester - Select DIAGNOSIS / OBD/MOBD / RADAR CRUISE / DATA LIST

        RADAR CRUISE 

        DATA LIST

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Country* (FRS) Front millimeter wave radar sensor country signal/JPN, NA, EURO, GEN Actual country code -
      2. Techstream - Select. Powertrain / Radar Cruise / Data List.

      Radar Cruise 

      DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Country* (F Radar Sens) Front millimeter wave radar sensor country signal/JPN, NA, EURO, GEN Actual country code -
    2. Read the DATA LIST and check the country specification information of the front millimeter wave radar sensor and vehicle.

    Result 

    RESULT CHART

    Result Proceed to
    Country specification information for vehicle and front millimeter wave radar sensor match A
    Country specification information for vehicle and front millimeter wave radar sensor do not match (Japan*↔Europe, Japan↔North America) B
    Country specification information for vehicle and front millimeter wave radar sensor do not match (North America*↔Europe) C

    HINT:

    • The country specification information of the driving support ECU is decided by the combination meter Even if the vehicle and sensor country specification information match, if the country specification information for the vehicle and ECU/meter do not match, it is necessary to replace the ECU and meter.
    • When the country specification information (North America*→Europe) for the vehicle body and sensor do not match, the sensor's information can be overwritten by performing the sensor's axis adjustment.

    B: REPLACE FRONT MILLIMETER WAVE RADAR SENSOR  (See REMOVAL )

    C: ADJUST FRONT MILLIMETER WAVE RADAR SENSOR  (See REMOVAL )

    A: REPLACE COMBINATION METER AND DRIVING SUPPORT ECU