Installation

3UR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

INSTALLATION





1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket to the sensor.
(b) Using a 19 mm deep socked wrench, install the sensor.
Torque: 20 Nm (200 kgf-cm, 14 ft-lbf)
(c) Connect the sensor connector.
2. ADD ENGINE COOLANT Service and Repair
3. INSPECT FOR COOLANT LEAK Testing and Inspection
4. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
5. INSTALL UPPER RADIATOR SUPPORT SEAL Installation
6. INSTALL ENGINE ROOM SIDE COVER RH Installation
7. INSTALL ENGINE ROOM SIDE COVER LH Installation
8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation
9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Installation
10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Installation