How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the lighting system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 
3. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

4. INSPECT CAN COMMUNICATION SYSTEM* 
   1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result 

      RESULT
      
      

      Result	Proceed to
      CAN communication system DTC is not output	A
      CAN communication system DTC is output	B

   B: Go to   1 CAN communication system 

   A: Go to next step. 

5. CHECK FOR DTC* 

   Result 

   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output B `

   B: Go to step  8

   A: Go to next step. 

6. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  8

   A: Go to next step. 

7. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. (See DATA LIST / ACTIVE TEST  )
   2. (See TERMINALS OF ECU  )
8. ADJUST, REPAIR OR REPLACE 
9. CONFIRMATION TEST 

   NEXT: END