LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2010 >> IS 250C Standard >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Power Source Control Ecu (Service Information) >> Power Source Control Ecu >> Removal >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Power Source Control Ecu: Removal: Removal

  1. PRECAUTION 
    NOTE:

    w/ Navigation System for HDD: 

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. Refer to PRECAUTION .

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH 

    HINT: 

    Use the same procedure for the RH side and LH side. Refer to REMOVAL - Step 2 .

  4. REMOVE FRONT DOOR OPENING TRIM COVER RH 

    HINT: 

    Use the same procedure for the RH side and LH side. Refer to REMOVAL - Step 3 .

  5. REMOVE INSTRUMENT SIDE PANEL RH  . Refer to REMOVAL - Step 36
  6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 37
  7. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  . Refer to REMOVAL - Step 7
  8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  . Refer to REMOVAL - Step 39
  9. REMOVE POWER SOURCE CONTROL ECU 
    1. Remove the bolt and 2 nuts.
      Fig 1: Identifying Remove Power Source Control ECU
      GTY265320Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector to remove the power source control ECU.
scientia non olet · About LEMON Manuals