DTC P2121: Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance (2010 To 08/2009): Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Result

   Result	Proceed to
   DTC P2121 is output	A
   DTC P2121 and other DTCs are output	B

   HINT: 

   If any DTCs other than P2121 are output, troubleshoot those DTCs first.

B → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
   Fig 1: Depressing And Releasing Accelerator Pedal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
5. Read the values displayed on the Techstream.

   Standard Voltage

   Accelerator Pedal Operation	Accel Sensor Out No. 1	Accel Sensor Out No. 2
   Released	0.5 to 1.1 V	1.2 to 2.0 V
   Depressed	2.6 to 4.5 V	3.4 to 4.8 V

NG → See step   3 

OK → See step   6 

1. Replace the accelerator pedal sensor assembly. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Turn the engine switch off.
6. Turn the engine switch on (IG) and turn the Techstream on.
7. Start the engine and warm it up.
8. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
9. Enter the following menus: Powertrain / Engine / Utility / All Readiness.
10. Input the DTC: P2121.
11. Check the DTC judgment result.

    Result

    Result	Proceed to
    NORMAL (DTC is not output)	A
    ABNORMAL (DTC P2121 is output)	B

B → See step   7 

A → END