Data List / Active Test
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Smart Access, Main Body or Back Door* / Data List.
*: w/ Power Back Door System
- Read the Data List according to the display on the Techstream.SMART ACCESS (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D-Door Touch Sensor Driver side door touch sensor / ON or OFF ON: Sensor touched
OFF: Sensor not touched- P-Door Touch Sensor Front passenger side door touch sensor / ON or OFF ON: Sensor touched
OFF: Sensor not touched- D-Door Trigger Switch Driver side door lock sensor / ON or OFF ON: Sensor touched
OFF: Sensor not touched- P-Door Trigger Switch Front passenger side door lock sensor / ON or OFF ON: Sensor touched
OFF: Sensor not touched- Tr/B-Door Lock SW Back door opener switch assembly (lock switch) / ON or OFF ON: Back door opener switch assembly (lock switch) pushed
OFF: Back door opener switch assembly (lock switch) not pushed- Tr/B-Door Unlock SW Back door opener switch assembly (opener switch) / ON or OFF ON: Back door opener switch assembly (opener switch) pushed
OFF: Back door opener switch assembly (opener switch) not pushed- Ignition Switch Engine switch / ON or OFF ON: Engine switch on (IG)
OFF: Engine switch off- Unmatched Vehicle-ID No communication condition between vehicle and key (vehicle-ID) / Yes or No Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle- No Response No communication condition between vehicle and electrical key transmitter (response) / Yes or No Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle- Unmatch Code or Form No communication condition between vehicle and key (response code and format) / Yes or No Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle- Key Low Battery Low key battery / Yes or No Yes: Key battery voltage low
No: Key battery voltage normal- Power Save Cnt 10 Min Power save counter - 10 minutes / Min: 0; Max: 255 Within range from 0 to 255 - Power Save Cnt 5 Day Power save counter - 5 days / Min: 0; Max: 255 Within range from 0 to 255 - Power Save Cnt 14 Day Power save counter - 14 days / Min: 0; Max: 255 Within range from 0 to 255 - ID Code Difference(Resp) No communication condition between vehicle and key (ID code) / Yes or No Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle- C Code Difference No communication condition between vehicle and key (challenge code) / Yes or No Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle- Auto Entry Cancel SW Entry function cancel / ON or OFF Mode status displayed - Door Unlock Mode2 Door Unlock Mode / All or Driver Customization status displayed - Ignition Available Area Ignition available area / Front or All Customization status displayed - Parking Wait Time Parking wait time / 0.5s, 1.5s, 2.5s or 5s Customization status displayed - B-Dr Opening Operation Back door opening operation / Long, Twice, OFF Customization status displayed - Touch Activation Over Threshold Consecutive entry lock operation / Active or Not Active Customization status displayed - Key Low Battery Warning Low key battery warning / ON or OFF Customization status displayed - MAIN BODY (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))Tester Display Measurement Item/Range Normal Condition Diagnostic Note ACC SW Engine switch on (ACC) / ON or OFF ON: Engine switch on (ACC)
OFF: Engine switch off- IG SW Engine switch on (IG) / ON or OFF ON: Engine switch on (IG)
OFF: Engine switch off- RR Door Courtesy SW Rear door courtesy light switch RH signal / ON or OFF ON: Rear door RH open
OFF: Rear door RH closed- RL Door Courtesy SW Rear door courtesy light switch LH signal / ON or OFF ON: Rear door LH open
OFF: Rear door LH closed- Back Door Courtesy SW* Back door courtesy light switch signal / ON or OFF ON: Back door open
OFF: Back door closed- FR Door Lock Pos Front door RH lock position switch signal / UNLOCK or LOCK UNLOCK: Front door RH unlocked
LOCK: Front door RH locked- FR Door Courtesy Front door courtesy light switch RH signal / ON or OFF ON: Front door RH open
OFF: Front door RH closed- FL Door Lock Pos Front door LH lock position switch signal / UNLOCK or LOCK UNLOCK: Front door LH unlocked
LOCK: Front door LH locked- FL Door Courtesy Front door courtesy light switch LH signal / ON or OFF ON: Front door LH open
OFF: Front door LH closed- RR-Door Lock Pos SW Rear RH side rear door lock position switch signal / ON or OFF ON: Rear RH side rear door unlocked
OFF: Rear RH side rear door locked- RL-Door Lock Pos SW Rear LH side rear door lock position switch signal / ON or OFF ON: Rear LH side rear door unlocked
OFF: Rear LH side rear door locked- *: w/o Power Back Door System
BACK DOOR (POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT))*Tester Display Measurement Item/Range Normal Condition Diagnostic Note Courtesy SW Back door courtesy switch signal/ON or OFF ON: Back door open
OFF: Back door closed- *: w/ Power Back Door System
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Smart Access or Main Body / Active Test.
- Perform the Active Test according to the display on the Techstream.SMART ACCESS (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
Tester Display Test Part Control Range Diagnostic Note Overhead Tuner Power Supply ON Door control receiver assembly ON/OFF - MAIN BODY (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))Tester Display Test Part Control Range Diagnostic Note Trunk and Back-door Open Back door lock motor ON/OFF -