LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2010 >> SC 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Lighting System (Service Information)) >> Height Control Sensor >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Height Control Sensor: Installation: Installation

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR RH 
    1. Install the height control sensor link rear RH with the 2 nuts.

      Torque: 8.0 N*m (81 kgf*cm, 71 in.*lbf) 

    2. Align the matchmarks with the one on the height control sensor sub-assembly rear RH and bracket.
    3. Install the height control sensor sub-assembly rear RH.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    4. Connect the connector.
    5. Install a nut.
    6. When the work like the vehicle height may be changed is performed, for example, removal and installation of the height control sensor, or replacement of the suspension, etc., initialize the sensor, then adjust the optical axis. Refer to INITIALIZATION .
  2. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT  Refer to step  1
  3. PREPARATION FOR HEADLIGHT AIMING (Using a tester)  Refer to step  2
  4. PREPARATION FOR HEADLIGHT AIMING (Using a screen)  Refer to step  3
  5. HEADLIGHT AIMING INSPECTION  Refer to step  4
  6. HEADLIGHT AIMING ADJUSTMENT  Refer to step  5
scientia non olet · About LEMON Manuals