LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2011 >> CT 200h >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid Control System (Service Information) >> Hybrid Control System >> DTC P0AFC-129: Hybrid Battery Pack Sensor Module >> Confirmation Driving Pattern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Driving Pattern

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off.
  5. Turn the power switch on (READY).
  6. With the shift lever in D, depress both the accelerator pedal and brake pedal at the same time to raise the SOC to a sufficient level.
  7. Push the P position switch, check that the engine is stopped and move the shift lever to N.
  8. Set the A/C for maximum cooling.
  9. Leave the vehicle for a few minutes.
  10. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
  11. Check that permanent DTCs are cleared.
  12. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

    HINT: 

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals