DTC B2313: Glass Position Initialization Incomplete: Procedure

1. Turn the power switch on (IG) and initialize the power window regulator motor. Refer to INITIALIZATION .

NEXT: Go to next step 

1. Turn the power switch off.
2. Wait for at least 10 seconds, and then turn the power switch on (IG).
3. Check for DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC output from front LH motor	B
   DTC output from front RH motor	C
   DTC output from rear LH motor	D
   DTC output from rear RH motor	E

B → See step   4 

C → See step   3 

D → See step   5 

E → See step   6 

A → END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)