Cruise Main Indicator Light Circuit: Procedure
- PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)
- Select the Active Test, use the Techstream to generate a control command, and then check that the combination meter operates.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indic. Lamp Cruise CRUISE main indicator light ON / OFF - OK
Indicator light turns on.
NG → See step 4
OK: Go to next step
- Select the Active Test, use the Techstream to generate a control command, and then check that the combination meter operates.
- READ VALUE USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)
- Check the Data List for proper functioning of the CRUISE main indicator light.RADAR CRUISE
Tester Display Measurement Item/Range Normal Condition Diagnostic Note CCS Main SW-Ready Dynamic radar cruise control system standby condition/ON or OFF ON: Switch ready is SET
OFF: Switch ready is UNSET- OK
When cruise control main switch operation is performed, the result will be same as above.
NG → See step 5
OK → See step 3
- Check the Data List for proper functioning of the CRUISE main indicator light.
- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- GO TO METER / GAUGE SYSTEM. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE ECM. Refer to REMOVAL