Power Distribution

POWER DISTRIBUTION: INTEGRATION RELAY: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. REMOVE REAR NO. 2 FLOOR BOARD Removal

3. REMOVE REAR DECK FLOOR BOX Removal

4. REMOVE REAR NO. 3 FLOOR BOARD Removal

5. REMOVE DECK FLOOR BOX RH Removal

6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE Removal

7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE NO. 1 RELAY BLOCK COVER

(a) Disengage the 3 claws and remove the No. 1 relay block cover as shown in the illustration.





9. REMOVE NO. 1 INTEGRATION RELAY

(a) Disengage the 2 claws and pull up the No. 1 integration relay as shown in the illustration.





(b) Disconnect the 3 connectors and remove the No. 1 integration relay.