Installation

SEAT: POWER SEAT CONTROL ECU (for Rear No. 2 Seat): INSTALLATION

NOTICE:
* If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU Rear Power Seat Control System.
* If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU Rear Power Seat Control System.

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL FOLD SEAT CONTROL ECU

(a) Install the ECU with the 2 nuts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the 2 connectors.

(c) Install the 3 clips.

2. INSTALL DECK BOARD ASSEMBLY Installation

3. PERFORM INITIALIZATION

NOTICE:
* If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU Rear Power Seat Control System.
* If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU Rear Power Seat Control System.

4. CHECK REAR NO. 2 SEAT

(a) Check the power seat operation Operation Check.