DTC B2288: Steering Lock Signal Circuit Malfunction: Procedure

1. Clear the DTC. Refer to DTC CHECK / CLEAR .
2. Check for DTCs 18 to 22 seconds after the engine switch is turned on (IG).
   RESULT
   
   

   Result	Proceed to
   DTC B2288 is output	A
   DTC B2285 is output	B
   DTC is not output	C

B → See step   5 

C → See step   7 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Check for Steering Lock System DTC.
   RESULT
   
   

   Result	Proceed to
   DTC is not output.	A
   DTC is output	B

B → See step   6 

A: Go to next step 

1. Check if the steering lock is released when turning the engine switch on (ACC).

   OK

   The steering lock is released.

NG → See step   7 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Power Source Control ECU / Data List.
5. Read the Data List according to the display on the Techstream.

   HINT: 

   When using the Techstream with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5-second intervals or less until communication between the Techstream and vehicle starts.

   POWER SOURCE CONTROL
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Steering Unlock Switch	Steering lock condition / ON or OFF	ON: Steering is unlocked (Engine switch on (ACC)) OFF: Steering is locked (Engine switch off)	-

   OK

   "ON" (Steering is unlocked) and "OFF" (Steering is locked) appear on the screen according to vehicle operating conditions.

NG → See step   8 

OK → See step   9