DTC C1442: Invalid Data Received from Acceleration Sensor; DTC C1443: Invalid Data Received from Yaw Rate Sensor: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Start and idle the engine for 60 seconds, and then stop the engine.
3. Check if the same DTC is recorded. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs (C1442 and/or C1443) are output	A
   DTCs (C1442 and C1443) are not output	B

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .

B → See step   2 

A → See step   3