Typical Enabling Conditions
WARNING: This page is about a different car, the 2012 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
ALL
| Monitor runs whenever these DTCs are not present | None |
P0335: RANGE CHECK/RATIONALITY
| Time after starter off to on | 3 seconds or more |
| Number of VVT sensor signal pulse | 6 times |
| Battery voltage | 7 V or more |
| VVT sensor circuit fail | Not detected |
| Engine switch | On (IG) |
P0335: VERIFY PULSE INPUT (CASE 1)
| Starter | Off |
| Engine speed | 600 rpm or more |
| Time after starter on to off | 3 seconds or more |
P0335: VERIFY PULSE INPUT (CASE 2)
| Starter | On |
| Minimum battery voltage while starter on | Less than 11 V |