DTC P060D: Internal Control Module Accelerator Pedal Position Performance: Procedure

WARNING: This page is about a different car, the 2012 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

READ OUTPUT DTC (DTC P060D)

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear the DTCsRefer to DTC CHECK / CLEAR .
Turn the engine switch off.
Turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.

Read the DTCs.

Result

Result	Proceed to
DTC is not output	A
DTC P060D is output	B

B → See step 3

A → See step 2

CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
REPLACE ECM. Refer to REMOVAL