DTC P1023: Camshaft Position Signal Output "B" Circuit; DTC P2614: Camshaft Position Signal Output Circuit / Open: Procedure

1. Replace the camshaft timing control motor. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG) and turn the Techstream on.
3. Clear the DTC. Refer to DTC CHECK / CLEAR .
4. Turn the engine switch off and wait for least 30 seconds or more.
5. Turn the engine switch on (IG) and turn the Techstream on.
6. Start the engine and idle it for 10 seconds.
7. Enter the following menus: Powertrain / Engine / Trouble Codes.
8. Read the DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   Other DTCs are output	B

B → See step   3 

A → END