Display And Navigation Assembly: Installation: Installation

HINT: 

A bolt without a torque specification is shown in the standard bolt chart. Refer to SPECIFIED TORQUE FOR STANDARD BOLTS .

1. INSTALL NO. 2 RADIO BRACKET 
   Fig 1: Identifying No. 2 Radio Bracket And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Install the bracket with the 2 bolts.
2. INSTALL NO. 1 RADIO BRACKET 
   Fig 2: Identifying No. 1 Radio Bracket And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Install the bracket with the 2 bolts.
3. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET 
   1. Connect the connectors.
   2. Insert the display and navigation module display with bracket to attach the 6 clips on its backside.
      Fig 3: Pushing In Display And Navigation Module

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the display and navigation module display with bracket with the 2 bolts.
      Fig 4: View Of Lower Display And Navigation Module Display Bracket Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET  . Refer to INSTALLATION - Step 4
5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 4
6. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 5
7. INSTALL NO. 3 BOX PANEL  . Refer to INSTALLATION - Step 6
8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  . Refer to INSTALLATION - Step 7
9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  . Refer to INSTALLATION - Step 9
10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  . Refer to INSTALLATION - Step 8
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
12. INSTALL COWL TOP VENTILATOR LOUVER RH  . Refer to INSTALLATION - Step 11